Uponor Combi Port M-Base HeatInterface RC
RC version for domestic hot water and direct heating with radiator connection (no mixing circuit). Mixing circuit can be upgraded by using the dedicated cabinet with installed UFH mixing group (Uponor Combi Port M-Base Cabinet+manif IW-UFH). Bypass function can be upgraded by using special accessory - Uponor Combi Port M-Base Heat Bypass.
Dimensioning codes:
15,19 – domestic hot water capacity indication (l/min)
CB – copper brazed stainless steel heat exchanger for domestic hot water preparation
TL – thermostatic temperature limiter for domestic hot water with submersible sensor
ZV – zone valve in residential heating circuit return line without actuator
NI – no pipe insulation and/or insulated cover
Item details
Documents
Technical manuals
Installation and Operation Manual Combi Port M-Base (1143311)
Technical Information Combi Port and Aqua Port (1094902)
About
Specification
- port completely assembled and pressure tested
- pipe clamps made of plastic for sound protection and thermal decoupling
- DVGW certified PM Valve with patented triple-sealing technology
- cold water outlet
- spacer for heat meter 110 mm x3/4"
- spacer for water meter 110 mm x3/4"
- venting and drainage valve
- strainer for primary heating supply line 0,5 mm
- connection possibility (marked) of an electrical earthing lug
- max. operating pressure heating: PN10
- max. operating pressure sanitary: PN10
- max. operating temperature: 85 °C
- min. pressure sanitary: 2,0 bar
- fitting material sanitary: CW617N
- fitting material heating: CW617N, CW614N
- pipe material: stainless steel 1.4401
- measurements: W/H/D 556 x 620 x 110 mm
Application
- Decentralized instantaneous domestic hot water generation
- Underfloor heating systems
- Radiator heating systems
Certification
- DVGW approval
Product drawings
Z-drawing
Rendered
Label drawings
Similar products
Uponor Combi Port M-Base Cabinet+manif IW-UFH
In-wall mounted cabinet including feet, heating manifold, and rail with pre-installed ball valves and mixing circuit for extension of the Uponor Combi Port M-Base HeatInterface RC to UFH version.
Dimensioning codes:
HMV – set of Vario-S manifolds for heating with _ (4,6,8) heating circuits
BV – set of 7 ball valves pre-installed on the mounting rail inside the cabinet for heat interface connections
MS – mixing set with heating pump, thermostat, and non-return valve for apartment heating circuit