Fittings and Accessories

- Elbow set for connecting the casing pipe
- ABS half sheels with insulation and reducer
- Traffic load of 60 tons

- Straight set for connecting the casing pipe
- ABS half sheels with insulation and reducer
- Traffic load of 60 tons (for dimension 250 : 40 tons)

- Balance different casing pipe dimensions in an insulation set

- Straight set for connecting of casing pipe
- Pipe piece with two shink sleeves
- Traffic load 60 tons

- H-set for connecting the casing pipe from single to twin lines
- ABS half sheels with insulation and reducer spigots
- Additional rubber end caps needed for tightness
- Trafffic load with special concret construction possible

- Chamber for connecting the casing pipe
- PE body with insulation and reducer spigots
- T and X models available
- Traffic load of 500 kg, higher load with special concret construction possible

- Filling radial gaps in chamber or other outlets
- Only use in combination with shrink sleeves

- Seal casing pipe with chamber or other casing outlets

- Pre-insulated PE-Xa pipe elbow
- One medium pipe PE-Xa, SDR 11
- Max. Load 6bar / 95°C
- PUR foam, PE casing

- Pre-insulated PE-Xa pipe elbow
- Two medium pipes PE-Xa
- Max. load 6 bar / 95°C
- PUR foam, PE casing

- For concrete core hole or fibre cement pipe
- Part to seal the casing pipe
- Applicable for PWP (pressurized water)
- Watertight up to 0,3bar

- For concrete core hole or fibre cement pipe
- Part to eliminate radial stress of the casing pipe
- Used with Uponor wall seal PWP