Smatrix Base PRO

- supports up to 6 room thermostats and 8 actuators
- option to extend up to 12 room thermostats and 14 actuators with 1071686
- max. power input per actuator: 24VAC / 0.2A (0.4A peak)
- protection class: Class II IP20
- color: grey RAL7015

Consisting of:
- Uponor Smatrix Base PRO controller X-147 Bus 6X
- quick guide, security instructions
- micro SD card (pre-inserted)
- DIN rail (length: 37cm)
- mounting material

- suited for Modbus RTU systems
- supports up to 6 room thermostats and 8 actuators with option to extend to 12 room thermostats and 14 actuators (with 1071686)
- contains data points for heat pump integration
- max. power input per actuator: 24VAC / 0.2A (0.4A peak)
- protection class: Class II IP20

Consisting of:
- Uponor Smatrix Base PRO controller X-148 Modbus RTU
- quick guide, security instructions
- DIN rail (length: 37cm)
- mounting material

- sparepart touchpanel for Uponor Smatrix Base controller X-147 Bus 6X
- protection class: Class II IP20
- color: white RAL9016

Consisting of:
- Uponor Smatrix Base PRO interface I-147
- power supply
- mounting material
- wall bracket
- instruction leaflet

- room temperature and relative humidity sensor (flush mounted)
- protection class: IP30
- color: white RAL9016

Consisting of:
- Uponor Smatrix Base PRO room sensor+RH Style T-141 Bus
- mounting material

- connects a Uponor Smatrix Base PRO controller X-147 with a BMS or third-party KNX devices
- power supply: 230VAC (+10%/-15%) / 50/60Hz
- internal fuse: T5 F3.15AL 250V, 5x20 3.15A quick acting
- operating temperature: 0°C ... +45°C
- storage temperature: -20°C ... +70°C
- max. consumption: 45W
- power connection: 1m cable with europlug
- connection terminals for system bus: 0.2mm² ... 1.5mm²
- protection class: IP20 II

Functions:
- room temperatur from Uponor Base or third-party KNX thermostats
- room setpoint from Uponor Base or third-party KNX thermostats
- room relative humidity from Uponor Base or third-party KNX thermostats
- room floor temperatur from Uponor Base or third-party KNX thermostats
- actuator status from Uponor Base or third-party KNX system
- foreced ECO from Uponor Base PRO or third-party KNX system
- pump output from Uponor Base or third-party KNX system
- boiler output from Uponor Base or third-party KNX system
- heating/cooling curve settings/circuit from Uponor Move PRO to BMS or vice versa
- heating/cooling modes from Uponor Base PRO to BMS or vice versa

Consisting of:
- gateway module R-147 KNX
- power supply
- mounting material (2 screws and 2 wall plugs)
- quick guide